Advanced search
72 search results
Page 5 out of 8 Pages
- Torque: Are there any known issues with using FQDNs instead of short hostnames for interactive/compute nodes
Answer: Issue: Are there any known issues with using FQDNs instead of short hostnames for interactive/compute nodes for Torque/MOAB? Solution: You can use the FQDN or the short name. ... - Torque: Why does TORQUE send the mom hierarchy to down nodes?
Answer: Issue: Why does TORQUE send the mom hierarchy to down nodes? I have 6 node (out of 590) that are marked down and/or offline. I have 5000+ messages ... - Moab: Why does Moab provision every compute node in a multi-req request?
Answer: Question: Why does Moab provision every compute node in a multi-req request? Solution: Moab supports advanced multi-req resource requests within the same job using the msub/qsub "-L" syntax. For ... - Moab: How can I run two applications in one job request in the Cray environment with
Answer: Question: How can I run two applications in one job request in the Cray environment with one on Haswell compute nodes and the other on KNL ... - Torque: How can I see which gpu is being used by a job?
Answer: Question: There are multiple gpus on our nodes. How can I see which gpu is being used by a job?Answer: Torque reports the gpu that ... - Moab: What was resolved in the Moab Workload Manager 9.1.0 release?
Answer: The following list are items that were resolved in Moab v9.1.0 release: Moab was not reporting the correct task count for jobs that allocate ALLPROCS The systemd ... - HotFixes: Hotfix Releases for TORQUE 6.0.x
Answer: The hotfixes listed below are not meant for general consumption. If you believe one may be applicable to your environment, please open a support case ... - Moab: How to configure scheduling leeway for transient load
Answer: Problem: Moab indicates that nodes are Idle in mdiag -n, checknode, showq, etc., but in reality they have higher load, and jobs will not run ... - Torque: Enabling and configuring support for cgroups in Torque
Answer: Question: What's involved in configuring the compute nodes to use cgroups? Solution: Before following these instructions, make sure to verify them against the latest "Installation and Configuration Guide". For ... - Moab: Configuring a submit node
Answer: Problem: Configuring a submit node to submit workload from. If done incorrectly, can gerate errors such as: ERROR: cannot establish connection - Operation now in progress (hostname:port=:42559) Unable ...
The most popular searches are:
- the (2688x)
- moab.key (2221x)
- file (1696x)
- "moab.db" (1475x)
- time (964x)
- what determines next node avaiable (961x)
- what+determines+next+node+avaiable (637x)
- gpu (496x)
- qdel array (304x)
- condo (238x)